Tips: Add some z-offset if you have compression issues on the Mighty 8K. In my case here, my first cube is 1.16mm smaller. So I recalibrated my printer again, but this time

$ 14.00

4.8 (534) In stock

Soo I did a PID tuning on my Ender 3. The problem is that I'm a little bit confused and not so happy about the results. After applying the new parameters I noticed that my printer still overshoots the initial temp. I repeated the process with the same result. More

Tips: Add some z-offset if you have compression issues on the Mighty 8K. In my case here, my first cube is 1.16mm smaller. So I recalibrated my printer again, but this time

Tips: Add some z-offset if you have compression issues on the Mighty 8K. In my case here, my first cube is 1.16mm smaller. So I recalibrated my printer again, but this time

Soo I did a PID tuning on my Ender 3. The problem is that I'm a little bit confused and not so happy about the results. After applying the new parameters I

How long does it usually take you guys to print a Cone of Calibration? : r/resinprinting

Tips: Add some z-offset if you have compression issues on the Mighty 8K. In my case here, my first cube is 1.16mm smaller. So I recalibrated my printer again, but this time